Page 593 - MiSUMi FA Mechanical Components Economy Series

Economy Series
Quality Assurance Photo Microsensors

· Advantage 3: Widened welding spot spacing of substrate , fully automatic welding process, and not easy to short circuit

Generic products in the market * MISUMI Economy series

Welding spot
spacing of
substrate is
The welding widened to
spot spacing 2. mm
of substrate is Fixed cable
only 2.1mm
position, and
not easy to
short circuit

· Advantage 4: Full automatic inspection, with guaranteed product quality

2 Full automatic inspection equipment 213 tests completed at one time Sensors Proximity
P.579
Initialization Settings Consumption Current Test (Normally Closed
(NormallyClosed LoadCurrentandResidualVoltageTest
Pause Message Consumption Current Test (Normally Open Microsensors Photo
(Normally Open Load Current and Residual Voltage Test
P.589
Short Circuit Protection Test (Normally Closed Short Circuit Protection Test (Normally Open
Power Supply Reverse Connection Protection Test Tail Swing Test
Oscilloscope Frequency Test (Normally Open Oscilloscope Frequency Test (Normally Closed Probes Contact
Test End
P.595
12
* Generic products in the market are similar products randomly purchased by our company from online or offline markets

2Usage Method Probes Sensors / Contact

2Mounting Method M3 Screw 2Connector Type
· When fixing the body Spring Washer · Plugging and unplugging steps of connector
with screws, use M3 Hook
VFUHZV ĭ PP ZDVKHUV Flat Washer Insert the connector directly into Wiring Tab
and control the tightening ( (O.D. П PP the sensor until the connector tab is
torque below 0.5N·m locked in place by the sensor hook.
2Welding (Sensor)
When pulling out, make sure that 5N or Less
· If welding directly on the terminal, please strictly follow enough force is applied to release
the conditions given below.
the connector tab from the hook.
Sensornsor
Welding 1.5mm Then pull it off.
Temperature RU /HVV
Welding 3 or Less Welding Precautions: Make sure to hold the connector
W
Time Position when plugging and unplugging it.
Welding Refer to the In addition, do not hold terminals or
Position right diagram cables. Otherwise, it will cause
poor contact.
590