Page 14 - Bosch Boiler House Component
P. 14

14 | Boiler house components






          Flue gas heat exchanger ECO stand-alone


          The flue gas heat exchanger is designed to save energy   valves are fully assembled and included in the scope of
          through lowering the flue gas temperature by heating   delivery as well as the thermal insulation ex works.
          the mains return flow water.
                                                                Benefits at a glance:
          Flue gases contain significant heat potential at high    Increase of the boiler efficiency
          temperature. Economizer modules with their highly-     Reduction of the fuel consumption
          efficient heat recovery surfaces utilise this heat potential    Easy retrofitting of existing systems
          and thus increase the boiler efficiency of new or existing
          steam boiler systems significantly. The flue gas heat
          exchanger is installed downstream of the boiler and is
          used for "dry" operation for heating up feed water. To
          use the condensing heat, the flue gas condensation
          can take place in an additional downstream flue gas
          heat exchanger module and make-up water can be
          heated up. The subsequent installation in existing
          single-flame tube steam boiler systems can be carried
          out very easily by these modules.

          Construction
          In the lower part, the flue gases are collected and flow
          through the integrated heat exchanger in the upper
          part for heat recovery.


          Equipment level
          The module is mounted on a stable base frame and has
          rails at the back for transportation. Servo drive, piping
          of the connections, flue gas control and drain shut-off





          Steam distributor SD


          In the distributor, the generated steam mass flow is
          distributed to the consumer and residual moisture is
          separated and drained.


          Construction
          A collecting pipe with an order-related number of pipe
          outlets is fully assembled with flange connections and
          all necessary fittings into a module unit.

          Equipment level                                       Benefits at a glance:
          The distributors are fitted with pressure indicators,     Reduction of network losses by centralised distribu-
          shut-off, non-return and condensate drain valves and    tion for systems with complex consumer structures
          will be delivered thermally insulated.                  Savings thanks to centralised operation and mainte-
                                                                  nance
   9   10   11   12   13   14   15   16   17   18   19