Page 879 - MiSUMi FA Mechanical Components Economy Series

Product Overview Economy Series
Linear slide rail

YV 6WDQGDUG 7\SH
Economy series 6DYLQJ
8S WR
Linear Slide Rails MISUMI LOGO ᵓᵗ

Smooth sliding and durableduurabble
New product with tap for p for Handles
easy installation P.825

Hinges
2Durability Test 2Salt Spray Test P.841
· MISUMIEconomy serieslinearsliderailis · MISUMI Economy series linear
stampedwithhigh-qualityself-mademold,andthe slide rail (steel) ensures 24 Knobs
assemblyaccuracyoffinishedproductsis hours salt spray test without
guaranteed.After50,000cyclesofreciprocating P.858
movementwithload,itcanstillbeusednormallyin rusting and excellent rust
smoothslidingwithoutdeformationinappearance. prevention performance.
Test Conditions: Install the sample correctly on the durability tester, load 24.5kg in the drawer, make rail Linear slide
continuous pushing and pulling movement with a speed of 12 cycles/minute, observe the change of the Test time (H) Generic products in the market * MISUMI Economy series
sample and record the state of the product when the corresponding number of cycles is reached. 24 Black spots appear in one place Normal
Number of cycles Sliding resistance Sag when fully extended P.876
10000 0.8kg 1mm 48 10% black spots at the inner rail 2% black spots at the inner rail
20000* 0.8kg 1mm 72 Large area of rust at the outer rail 3% black spots at the outer rail 17
30000 0.7kg 1mm
40000 0.7kg 1.2mm 96 Large area of red rust inside the Black spots inside the slide rail
50000 0.7kg 1.2mm slide rail with steel ball rusted with steel ball rusted
* With opening and closing every ten minutes, 20000 cycles is about equal to the * Generic products in the market are similar products randomly
number of uses in a year. purchased by our company from online or offline markets Knobs / Slide Rails Handles / Hinges /
* The test data are obtained through testing by our company, which are for reference only * The test data are obtained through testing by our company, which are for reference only
2Installation PrecautionsInstallation Precautions
2

Process Hole Sectional Sectional View
View of with Tap
Normal Type Accessories
Outer Rail Mounting Hole Accessories Required: Screw
Required:
When installing the interference part between the Screw + Nut
slide rail and the mounting hole, please move the
process hole to a position above the mounting hole
before installing the screws.
2Precautions for use
· Example of installation direction · Linear slide rail when ball creep occurs
Offset due to
Inner Slide Rail Retainer ball creep Outer Slide Rail
When normal

When creeping
Vertical and parallel installation Linear slide rails are not mounted vertically Because of the offset, the retainer has reached the left end of the outer slide rail, but it is not in the full stroke state.
In order to eliminate the ball creep phenomenon, please apply force to make the inner slide rail slide to the full stroke state.
Action
Direction ʏ Action Force Force
Force Direction Direction Direction
Direction
Apply force to the far center of gravity ʏ
Linear type rails are not on the same horizontal line when it is installed horizontally
* It is recommended not to use it when torque loads are withstood Before pulling out After pulling out
876